![]() ![]() Cover the leak with the patch, but be sure to avoid air bubbles or wrinkles in it that could further allow water to leak and let the adhesive set fully.ĭepending on the bond, this could take up to a few hours or even a day. The patch should be removed from its paper backing if it has one. This step can be skipped if your patch kit does not contain an adhesive compound. If you are using a patch kit that includes an adhesive compound, apply a thin layer around the leak-it is typically epoxy or another adhesive and needs to be set up slightly before the patch can be applied. Search for wet spots around the area to find where the leak is. Leaks in preformed liners are often noticeable cracks or tears, but they are hard to locate in shallow ponds. Locate the Leak and Clean the Pond’s SurfaceĪfter locating the leak, you may mark the leak’s location in the liner with a grease pencil or other marking tool. This way, they won’t be affected by the falling water level when you drain the pond. When you empty your garden pond, fill the holding tank, buckets, or other containers with pond water and remove the pond’s fish, plants, and rocks. The following is a step-by-step guide on how to fix molded pond problems using repair kits: Remove Fishes, Pond Plants, and Drain Your Pond Following the identification of the leak’s cause, it’s time to decide how to fix it. In order to fix a leaking pond liner, you should first make sure it’s the liner and not something else that’s causing the leak. Croix pre-formed ponds.Step-by-Step Guide: How to Fix Your Preformed Molded Ponds Using Repair Kits Dirt and sediment will rest upon the rocks, becoming less noticeable.ĭecorate with rocks, bridge, aquatic plants, lighting, fountains, or whatever your imagination decides!Ĭombine two or more ponds for a larger, more dramatic presentation. If you got dirt in the pond while backfilling, it is a good idea to drain the pond completely, wipe clean (never use detergents) and refill with water.Ī layer of washed, lightly colored stone (pea gravel, cobblestones) may be arranged within the pond prior to stocking. If you are adding fish, you need to dechlorinate the water by using Ammo Lock 2 before adding fish. If water is chlorinated, allow 48 hours before adding plants. Gauge your time so the filling of water and backfilling of sand steps are finished at the same time. Commence filling with water slowly and continue backfilling with loose sand. Backfill with loose dirt or sand between pond and excavation, stopping at halfway mark between excavation base and pond's flange (upper lip). You should have the pond's edge slightly above ground level so the dirt around it slopes at least 10% away from the pond to prevent rain from washing soil, lawn fertilizers, etc. Bed the pond on a layer of sand, then level the pond. Rinse out pre-formed pond with water real well before installing.Ĥ. NOTE: For our molded shelf ponds, simply replicate the pond's contour within the excavation, making sure to fully support the shelf with tightly packed sand or dirt. 2" of play sand base under the pond and have some for around the edges. Take out any rocks, roots, or sharp debris. Make sure the excava- tion has a firmly compacted base. ![]() Dig a corresponding hole a little larger and deeper than the pond. You can outline it with chalk dust as well.ģ. Standing inside the pond, mark the pond's perimeter on the ground, using an edger or flat shovel. ![]() Select an area that is sunny and has at least 4-6 hours of sunlight. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |